11/3/2023 0 Comments Rivet nut installationThis is common for all spin-spin rivet nut installations. You can see the serration marks left on the head of the rivet nut from the rivet nut tool. Here is a properly installed thin wall rivet nut. Once the tool has stalled, depress the lower R position on the tool reversing the tool out of the installed rivet nut. The tool continues turning until the maximum torque load is achieved, thereby stalling the tool. The serrations on the face of the tool will hold the rivet nut in place while the threads of the rivet nut "ride up" the threads of the mandrel. Spin-Spin tools are also available in a Pistol Grip Version and a Right Angle Inline Version for difficult to access applications. *Can install these parts in stainless steel. SSG 900 Inline Style Series (17) Designed for installing steel or aluminum CAL, CAK, CAH, CAO, CFT/CAT*, CFW/CAW*, and CPB Rivet Nut Inserts (thin wall only).įeatures quick change nose piece for head set replacement without tools. When the rivet nut starts to bend around the bottom edge of the hole, the serrations also bite into the edge creating an additional anchor point further increasing the rivet nut's resistance to spinning in the hole. Note- As the rivet nut expands in the hole, the serrations will bite into the parent material. This will thread the tool into the rivet nut. Once the rivet nut is inserted into the hole, press the trigger in its top F position. Next, insert the rivet nut into the proper hole in the workpiece. This prevents the rivet nut from cross threading the socket head cap screw mandrel. To begin the process of installing a thin wall rivet nut with one of our spin-spin tools, first turn the rivet nut onto the threaded mandrel 1-2 turns. Mandrels should be replaced when excessive thread wear occurs with a high quality socket head cap screw.īefore installing a rivet nut, it is important to ensure that the mandrel extends at least one thread beyond the end of the rivet nut. It is also recommended to lubricate the mandrel to increase performance. Sherex recommends the use of an air regulator, air filter, and lubrication system to reduce the wear of internal components. High temperature grease should be used to lubricate the bearing set. Spin-Spin tools are also available in an Inline Version and a Right Angle Inline Version for difficult to access applications. *Can install these parts in stainless steel SSG 800 Pistol Style Series (20) Designed for installing steel or aluminum CAL, CAK, CAH, CAO, CFT/CAT*, CFW/CAW*, and CPB Rivet Nut Inserts (thin wall only).įeatures quick change nose piece for head set replacement without tools.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |